Feature request: controller mapping inversion

[Fraxis]

Would it be possible to add an option to either controller behaviour when mapping a parameter to to a knob, slider etc. on the hardware controlling the GX-80 please? I have a Roland synth with its combined pitch bend / modulation controller and if, for instance, I map 'Brilliance' to it (the one to the right of the Tone Selector presets) the default position becomes full brilliance, whereas I'd like it to start at no brilliance and be able to push up the controller to increase brilliance. Given the 'pull forward' nature of the GX-80's sliders, I think being able to flip the response would be a good usability option to have in general. Thanks.

[Steve W]

Invert CC Slider or Knob.png (22.54 KiB) Viewed 5427 times

1. Press the midi on the control bar.
2. Rotate the Max and Min values.

PS: Thanks for mentioning this. While I was in there, I inverted my Feet. Now low CC value = longest pipe / lowest tone and vice versa. I was too lazy to change it when I tested that and forgot I had that set up.

[Fraxis]

Thanks Steve. I will give a try.