Oh no ! Feature request already !

[UrbanCyborg]

Go into the settings for the instrument (click on the gear wheel at the top), select the Interface tab, and see whether the "On Control Double-click:" item is set to edit the control's value or select it's default value. It sounds like yours is set to edit the value. If it's the other behavior you want, just change the setting.

Reid

[StudioAndromeda]

Perfect, thank you BOTH very much for the help!

[jayuhfree]

Savable user temperaments?

[timg11]

Hi all, I have the CA2600, Elka0-X, and GX-80 in my toolbox of instruments. I have not used them extensively, but find them flexible and powerful.

I was intrigued by the announcement of the PS-3300 Synthesizer. I watched the Introduction to Cherry Audio's PS-3300 - Hosted by Tim Shoebridge on youtube to get a feel for it.

One thing that surprised me was that it has a single envelope generator for both VCF and VCA.
That seems like a limitation and shortcoming - maybe it was one of those tough compromises at the time of the original design, but does it need to be retained in the virtual world? Granted you want to retain the essence of the original instrument, but would adding a second envelope generator for the filter have any downside if it was optional to use? I.E. add a switch on the filter mod for "use EG2". Plenty of other enhancements and modernizations have been added. Even the humble 2600 has both ADSR and AR.

Other people's thoughts? Maybe this is a non-issue, but it really jumped out at me in a negative way.

[huggermugger]

One thing that surprised me was that it has a single envelope generator for both VCF and VCA.
That seems like a limitation and shortcoming - maybe it was one of those tough compromises at the time of the original design, but does it need to be retained in the virtual world? Granted you want to retain the essence of the original instrument, but would adding a second envelope generator for the filter have any downside if it was optional to use? I.E. add a switch on the filter mod for "use EG2". Plenty of other enhancements and modernizations have been added. Even the humble 2600 has both ADSR and AR.

You can patch the GEG (General Envelope Generator) in the master section into the VCF(s) instead.

[utdgrant]

You can patch the GEG (General Envelope Generator) in the master section into the VCF(s) instead.

Be aware that the GEG is monophonic, so your filter sweeps will end up being paraphonic. Admittedly, I love paraphonic synths, but I don't think this is what the OP desires.

GeneralEnvelope.jpg (30.47 KiB) Viewed 24232 times

[timg11]

Thanks @utdgrant - that's exactly correct. GEG is not the same thing.

Just to clarify why filter EG and amp EG benefit from being independent, consider the "classic" VCF sweep sound. You might want the VCF EG to sweep the filter cutoff down to a low sustain level, while maintaining the full VCA amplitude with a higher sustain value (or even an AR type of waveform) to keep the output strong as the filter closes. When the key is released then the release phase takes the amplitude to zero.

With a single EG, the higher-frequency filter-open part of the sweep will always have to be louder than the filter-closed part of the sweep.

Here's how it could be implemented:

[Phil999]

Savable user temperaments?

yes, the temperaments should be storable. For a single voice, and for all three voices. I understand that this can be a difficult thing for Cherry Audio, but here it is, the feature request.

Another feature request is to make the Master Tune global. I work with traditional music which requires a different tuning. I can do that by saving all changes to a preset, but it would be nice if one could just have a global tuning setting. The company U-he has a good solution for this; one can lock a parameter. Every new loaded preset will load with this particular parameter locked. This is something Cherry Audio should consider.