Bug in VM2500 1026 Preset/Voltage

[GBDarwin]

I might be missing something or otherwise mistaken, but when "linking" the VM2500 1027 to the 1026 the 1026 does not step correctly. It pulses twice on step 1 before moving to step 2 (which is step 3 on the 1027). If confusing maybe this will help:

1027-------1026
(step 1)-----(step 1)
(step 2)-----(step 1)
(step 3)-----(step 2)
(step 4)-----(step 3)
etc.

Thanks for any information.

[MRBarton]

This bug has been fixed and a new release is in the pipe. I will check that particular connection between the 1026 and the 1027 again before it goes out just to make sure. Thanks for the notification.

[Borellus]

Any update on this? I'd love to see the 1026 working properly.

[drohnee]

The latest version of the 1026 still exhibits this behavior. The 1050 module appears to sync step-by-step as expected with the 1027, but the 1026 does not.

Probably related, but if one drives the 1026 Link In with a 0-5V phasor, the 1026 often skips the last step or does not give the 8th step its full duration. The CV signal appears to require some amplification to get a steady 8-step sequence.

[Borellus]

The latest version of the 1026 still exhibits this behavior. The 1050 module appears to sync step-by-step as expected with the 1027, but the 1026 does not.

Probably related, but if one drives the 1026 Link In with a 0-5V phasor, the 1026 often skips the last step or does not give the 8th step its full duration. The CV signal appears to require some amplification to get a steady 8-step sequence.

Fortunately, I've found some similar functionality in these modules, but I'd really appreciate it if the 1026 were fixed:

https://store.cherryaudio.com/modules/w ... age-source

https://store.cherryaudio.com/modules/preset-voltage