Increase or decrease volume from a 1x8 switch ?

[elamid]

Hello everyone,

I'm using a 1x8 switch to start and stop a sequencer, at specific steps of the switch, and that works fine ...

But, I would like to automate a progressive volume increase from 0 to 100, when starting the sequencer, and a progressive volume decrease from 100 to 0 when stopping the sequencer ...

What would be your advices or tips to achieve this ?

Regards,
Eric.

[honki-bobo]

Hi Eric,

you can use a Glide module to fade in/out your signal and use the glide time to set the fade in/out length. Connect the same outputs from the 1x8 switch that are connected to the Start input of the sequencer to the input of the Glide module. Connect the Glide module output to the CV input of an amplifier and the signal you want to fade in/out to the amplifier's input you're good to go.

volumeslide.jpg (108.9 KiB) Viewed 1772 times

[elamid]

Hi honki-bobo,

Thank you so much for the tip ! That's exactly what I was looking for ...

Regards,
Eric.