Cherry Audio Forums

Hi,
Just a minor issue when using Partializer. I'm finding it difficult to adjust the little attenuverter controls as the adjacent jack i/o usually gets selected first. You have to carefully position the cursor to the upper-right of the dial in order to make work.

Mart.

Hi martb!

Thanks for bringing this to my attention. i will rework the attenuators and jacks. it's probably a z-order issue as you mentioned.
I will put out an update ASAP. sorry for the inconvenience.

Chris

An update with fixes for these issues and some bonus featurs is now submitted. I'll push it to the store as soon as it gets approved.

Chris

Excellent - Thanks Chris
Overall I really like the UI of your modules. You manage to get a lot of functionality into a pleasant looking interface. So a thumbs up from me anyway, FWIW.

Mart.

Hey Mart,

thanks for your kind words! it really means a lot to me and the whole R_Ware team <3

Partializer has now been updated to build#7 which fixes the issue you reported. thanks again for letting me know.

New in Build#7

• added R_Ware config menu -> access by hovering over the module's name and then clicking (right or left click) on the config menu button
• added the ability to lock the fundamental from being affected by the partial manipulation to the config menu (will enable and display lock switches)
• added the ability to detune by a negative amount to the config menu
• fixed Offset/Detune/Slope CV inputs adding an offset upon connection (Legacy behavior can be re-enabled in the config menu Legacy options )
• fixed artificial partial limit when Offset CV was connected
• fixed knobs and jacks overlapping/being hard to move

Thanks, just tried it and my reported issue is fixed. The additional stuff is a bonus of course
Cheers,
Mart.