Page 1 of 1
Andrew Macaulay's mid-side processor
Posted: Sun Jan 01, 2023 6:15 am
by theWholeSandwich
I am looking at this this thing thinking: "ok cool I can have the bass and kick in mono and start panning synths"...but it seems like I am going to need another mixer post eq. Any thoughts?
Re: Andrew Macaulay's mid-side processor
Posted: Sun Jan 01, 2023 4:16 pm
by honki-bobo
You shouldn't have to use a mixer after EQ. The basic setup would be to take your stereo signal and make it a mid/side signal. Then you pass the side signal through a HPF and transform the HPF and the mid signal back to stereo. To avoid phase issues due to delays introduced by the filter, also send the mid signal through a filter without altering it and use that to recreate the stereo channels.
Happy new year,
Martin
- Mono low frequency.jpg (63.79 KiB) Viewed 2218 times
Re: Andrew Macaulay's mid-side processor
Posted: Mon Jan 02, 2023 11:52 pm
by theWholeSandwich
Thanks! I think it's right... check it if you get time.
check out also how I used the Matrix Mixer to set up an alternate drum mix with a badass filter sweep! I am sure I can take out redundant modules as usual
Re: Andrew Macaulay's mid-side processor
Posted: Tue Jan 03, 2023 1:51 pm
by AndyMac
Wow, that's a really interesting patch - nothing more I can add, and loving your use of Matrix Mixer!
Re: Andrew Macaulay's mid-side processor
Posted: Wed Jan 04, 2023 4:08 am
by theWholeSandwich
I am certain I am using it well below its potential! I am happy I bought this stuff, although it seemed somewhat esoteric at first glance