What do the square buttons that cycle between blank, plus, and minus actually do? Not clear to me. Also, what are the settings for the unlabeled three way switch?
Weevil, more documentation would be appreciated.
Weevil Multi Osciillope
-
flucatcher
- Posts: 74
- Joined: Mon Jan 28, 2019 5:51 am
Re: Weevil Multi Osciillope
Hey, yes, documentation was a bit sparse. Its updated now:
Oscilloscope for up to 6 input signals.
Horizontal scale is defined by the scale knob and the scale switch:
HIGH - between 5 and 126 ms for the full screen
MEDIUM - between 126 and 5045 ms for the full screen
LOW - between 5045 and 196772 ms for the full screen
The knob above the input jack sets the vertical scale.
Button below the input jack decides when to trigger a redraw (+ means redraw when the signal switch from negative to positive, - means redraw when the signal switch from positive to negative). If no trigger button is checked it redraws continuously.
The STOP / RUN button allows you to freeze the oscilloscope.
Thanks for the feedback!
Oscilloscope for up to 6 input signals.
Horizontal scale is defined by the scale knob and the scale switch:
HIGH - between 5 and 126 ms for the full screen
MEDIUM - between 126 and 5045 ms for the full screen
LOW - between 5045 and 196772 ms for the full screen
The knob above the input jack sets the vertical scale.
Button below the input jack decides when to trigger a redraw (+ means redraw when the signal switch from negative to positive, - means redraw when the signal switch from positive to negative). If no trigger button is checked it redraws continuously.
The STOP / RUN button allows you to freeze the oscilloscope.
Thanks for the feedback!
Re: Weevil Multi Osciillope
Thank you Sir! It's a great tool.
Re: Weevil Multi Osciillope
Hi the Image in the documentation does not equate to the description. The Hi/Med/Low switch is not showing.
Sorry for being pedantic.
Sorry for being pedantic.